Eight recruit milking machine maintenance

by:Desing      2020-12-02
Milking equipment must be good maintenance to effectively do the milking. Respectively for milking machine parts, must be regularly test system, guarantee the milking machine always in good working condition.
clean parts every time after milking, should be timely cleaning milk after all parts. Cleaning method is: first rinse, then into the hot detergent ( Temperature 70 ℃, 1% of alkali) Inside, brush with wool washing, with 80 ℃ hot water wash, finally to dry and set aside.
cleaning, check the rubber in the rubber cover milk cup set should be cleaned down, but to prevent deformation due to water temperature is too high, at the same time, to check whether rubber set of intact don't leak, found a leak phenomenon, should be replaced immediately.
check set milk machine set milk device after cleaning, should check whether the rubber washer is in good condition, when assembling the holes of the walls open atmosphere.
prevent damage of glass tube of the milk pot cover glass tube HeJinKong switch, to handle with care in the cleaning process, to avoid damage, after assembly shall not leak.
maintenance pulsator pulsator and vacuum hose unpick and wash once a week, and check whether the pulsator rubber film is in good condition, whether wall holes and air flow. After assembled, in accordance with the 40 ~ 70 minutes of pulsating frequency adjust well, ready for use. Pulsator refueling should be carried out according to the requirement of the supplier.
in a timely manner to replace milk ducts to replace milk ducts in time, otherwise, on the one hand milking difficulties caused by its elasticity, on the other hand, any tiny crack on the surface will scale residual milk, provide the conditions for bacteria breeding.
inspect breast pump check once a week, such as check valve diaphragm rupture, air will enter the breast pump, but should be a breast pump check valve and set aside.
monthly check clean vacuum regulator, sensor and a vacuum pump belt use wet cloth rub-up vacuum regulator valve, seat, such as filter, clean with soap liquid sensor to dry before loading; With your thumb on the belt should be 1. 25 cm lengths, belts worn or damaged shall promptly replaced, replace or adjust the strap, should check whether the two wheel is on a straight line.




contributors: shandong KaiYin group shi-tao liu

if you think this net reprint content involved, the author of a work, please contact us as soon as possible. Telephone: information.

Custom message
Chat Online
Chat Online
Chat Online inputting...