Milking machine the usual maintenance

by:Desing      2020-04-02
Milking machine belongs to the more sophisticated tools, the operator must hold position, always mindful of its running status, ensure that there is problem when can get timely treatment, in order to avoid causing greater damage to the machine. In addition to the above system detection for milking equipment on a regular basis, completes the daily maintenance is necessary. 1. Cleaning parts in time, prevent the internal water milking machine every time after milking, should be timely cleaning milk after all parts. Cleaning method is: first rinse, then into the hot detergent ( Temperature 70 ℃, 1% sodium hydroxide solution) Inside, brush with wool washing, with 80 ℃ hot water wash, finally dry spare; At the same time, the cleaning is finished, to row while inside the trees. Especially in the winter in the north cold area, heating system, must be provided to prevent the residual water freezes inside the machine after cleaning machine, pipeline blocking or expansion tube machine damage, cause the next milking us from otherwise normal operations. 2. Regularly check damageable parts, found the problem immediately replace the milking machine regularly check the milk cup, milk, milk pump check valve, milk ducts and vacuum sealers and other vulnerable parts, see whether normal, found that the problem timely replacement. If when cleaning milk cup lining should be remove the wash separately, and prevent deformation due to water temperature is too high; At the same time, to check whether the milk cup liner is in good condition, such as have a flat or have milk leakage phenomenon, that has been damaged, should be replaced. Milking machine set breasts after cleaning, should check whether the rubber washer is in good condition, when it is assembled on the walls of pores and atmospheric flow, if the air inlet blockage, collection of breast milk cannot get rid of and can lead to a cup, and the harm of breast; The milk pot cover glass tube HeJinKong switch, to handle with care in the cleaning process, to avoid damage, after assembly shall not leak; Milk ducts, breast pump, the service life of the seals used in the check valve co. , LTD. , after damage should be replaced in a timely manner, otherwise not only influence milking effect, but also for milk scale residual, create conditions for bacteria breeding, affect the quality of milk. Always examine breast pump check valve, if check valve diaphragm rupture, air will enter the breast pump, so should have a breast pump check valve in case of urgent need. Check regularly clean vacuum regulator, sensors and vacuum pump belt, use wet cloth rub-up vacuum regulator valve, seat, etc. , clean with soap liquid sensor filter, dry again after installed; With your thumb on the vacuum pump belt, should be 1. 25 cm lengths, belts worn or damaged should be replaced in a timely manner; After replace or adjust the strap, should check whether the two wheel is on a straight line. 3. Preventive maintenance pulsator, maintain the vacuum pump carefully using milking equipment, so as to avoid damages to the machine. As in the case of oil-free vacuum pump, should be timely to add vacuum pump oil. Pulsator in use process, because the climate is different in different region, prone to dust and water vapor into ice, therefore, to regular cleaning maintenance pulsator, view the pulsator rubber film is in good condition, whether wall holes and air flow, and after assembled, according to 40 ~ 70 times/min pulsation frequency adjust good, ready for use.
Custom message
Chat Online
Chat Online
Chat Online inputting...